How To Ride
Reading a Bus Schedule
Read the schedule for your route and direction of travel
Find the schedule that will get you where you want to go. Decide if you will be traveling “Inbound” (toward Cincinnati) or “Outbound” (away from Cincinnati.)
Find Your Stop
Find the location at the top of the schedule closest to where you will catch the bus.
Find your stop times for your entrance and exit stops.
Read down the list of times under this location to see what time the bus will be at your stop. Read across to the timepoint closest to where you want to go. The time listed in that column tells you what time you’ll arrive at your destination.
Selecting the bus run that meets your schedule.
If you need to get somewhere at a specific time (like work or an appointment) do just the opposite. Look for the time you’d like to arrive under the location closest to where you’re going. Then read back to the timepoint closest to where you’re coming from to find out when you should catch the bus. It is sometimes necessary to transfer to complete your trip. (See Transferring.)
For safety reasons and efficiency, TANK buses stop only at designated bus stops. Bus stops are marked by a white sign with a TANK logo. TANK stops are found about every two blocks along a given route. When you see the bus coming, stand near the bus stop sign with your $1.50 fare in hand, so the approaching operator knows that you want the bus. Each TANK route has a number and a service area name. The service area name is the major area, city or community route that is served by the route.
All TANK buses have destination signs on the top front, above the windshield, and on the left side, near the front door. The destination sign tells you the route number and destination. The route name and / or destination may take a few seconds to cycle the complete message. Please be sure to read these signs carefully and completely to ensure that you are boarding the correct bus.
Exiting At Your Stop
TANK buses use enunciators to call out major stops, intersections, transfer points and destinations to help riders become oriented with the route. Drivers will also call out any stop upon request, if you ask when you get on the bus.More About Transfers
Signaling The Driver
All TANK buses are equipped with a passenger signal cord. The cord is located across the middle of the windows. Please pull the signal cord to request your bus stop about one block before the stop you wish to use.Lookup Route Stops